![]() ![]() This Spring3 KTE version will include an upgraded ultra premium transformer that is 100VA O-Type f lat wire type. The highest grade components are used in our very popular KTE version products. This is a popular option for those who want a little more out of their dac with improvement of sound from the caps as well as this version will include the cnc machined aluminum remote control. ) It has standard Red label 5N Copper Otype Transformer, round wire type copper wiring. (With HoloAudio caps for ultimate power filtration and improved sound quality – Sound quality is refined and more relaxed, transparent and details are more refined and clear while remaining neutral. Considered the base model however packs a mean punch for price per dollar performance ratio. It has standard Red label 5N Copper Otype Transformer, round wire type copper wiring. (The base model is quite good all by itself and priced so competitively it’s impossible to beat the performance/price ratio.) This model has basic caps for the PSU, and does not include a CNC remote. Below are the three levels, and KTE being our no compromise model with all options: Provides 84 steps, each step is 1db of volume control. Optional (Factory installed only): A fully balanced, fully discrete analog pre-amplifier.In addition, the I2S input can be configured with a specific pinout configuration, making it compatible with most of the HDMI-I2S digital devices on the market. A single, independent HDMI-I2S input interface is provided, which has a four-way independent circuit, as opposed to standard LVDS chip, making I2S clock signals subject to lower interference and lower jitter.The USB interface uses proprietary firmware with ultra-low latency, a highly reliable data transmission, ideal USB eye pattern measurements that contributes to 2-4 times higher performance than official firmware.(It can lock up to 1.5us-2us 1kHz signal with high jitter on the premise of almost being immune front-end jitter). Under the premise of being almost immune to the front-end jitter, it can also lock up to 1.5us-2us 1KHz signal with high jitter. It also uses a high-performance femtosecond VCXO as the PLL clock source. Using the ultimate performance of PLL+FIFO technology, provides 0.1Hz Third-Order low-pass ability to inhibit jitter.Based on this new generation of technology, “泉3” Spring3 (non preamp model) can provide a SINAD of >112dB and a dynamic range of >128dB, which represents the performance limit reached by today’s most advanced R2R architecture DAC. LIQUID NOTES FOR LIVE R2R FULL
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |